IO timing

You will learn

How IO timing is stated against a clock another chip drives, and what margins read from an SDF look like.

A pin's timing is stated against a clock another chip drives: set_input_delay and set_output_delay, negative before the edge, positive after. The widget shows what such margins look like when they are read instead of assumed: two recorded model runs over the routed E3 design for the AX7203 board (XC7A200T in an FBG484 package), printed -- smallest TX hold 3445 ps on eth_txd[1], smallest RX mid-nibble margin 10900 ps on rxctl_n, both PASS -- a model over nextpnr's own SDF of the routed design, not a board measurement, and it says so. The spec frame opens emitter_xdc.t27 again, the emitter these lines would go into.

Open the interactive lesson →